OTTER features a custom Hard Top, preferred CAT 375 engines (Port 8 hrs & Starboard 2,480 hrs), Westerbeke Generator (700 hrs), (5) new Batteries (August 2016), roomier V-Berth layout, Ultrasuede Salon, teak & holly sole, Cold Plate Refrigeration, New AC (installed 4/2017), St. Croix Davits, Dinghy & Outboard. Since purchasing in 2008, OTTER's knowledgeable owners have overseen upgrades and additions of equipment and systems: Added custom-designed & fabricated substantial hardtop and with full enclosure, Garmin GPS (2010), new helmdeck and exterior upholstery (2016), replaced all head piping, connectors & ducting (2016), renewed exterior varnish each year, and maintained the unblemished Flag Blue Awlgrip. Every winter, OTTER has been inside-stored.
Completed Spring 2017:
Fall, 2016, the port engine was found to have had a long-term water leak in one of the exhaust systems, allowing cooling water to enter the outboard aft cylinder and cause corrosion and pitting. A new ‘long block’ was installed over the winter (comprising cylinder block, crankshaft, pistons, cylinder head, injectors, oil cooler and valve gear). Apart from the external accessories and fuel system this is essentially a new engine. During this work, the turbocharger was also replaced as well as both exhaust manifolds.
This work carries a six month warranty, with unlimited hours, on both parts and labor.
Following completion of the work, the CAT dealer performing the above pressure tested the cooling system and the vessel was sea-trialed. Both engines ran correctly with the correct operating temperature and full RPM.
At the same time the A/C system was completely replaced with a new MarineAir system comprising 12,000 BTU compressor, evaporator and ‘SmartTouch’ keypad control.
For Further Information, To Assure Availability
and To Arrange Inspection,
Please Contact Leslie H. Quarrier, CPYB
Cell: 860-388-8701, Office: 860-767-3013
Sleeps a total of 2-4. The Master Stateroom offers the more spacious V-Berth with Filler layout (which makes into a large sleeping area). There is a closed chain locker above the berth, storage above and below the berth, a bureau with mirror over and a large hanging locker. The private Head is en suite and features hot & cold pressure water, cultured marble sink and vanity with storage, mirror, head and shower.
Next aft is the Main Salon with U-shaped Chamois Ultrasuede-covered settee to starboard, storage above and below and oval Grand Banks Teak Hi-Lo table (which, with the settee, can lower to convert to a berth). Vessel control panel is above the settee, on the aft bulkhead.
The complete U-shaped Galley is directly across, offering ample space to prepare the most elaborate feast or the simplest fare.
The interior is typical Grand Banks quality throughout, with varnished teak cabinets, drawers, trim, off-white laminate bulkheads, varnished teak & holly cabin sole, comfortable seating, stainless steel opening ports with screens, hatches, overhead lighting, reading lamps - all tasteful.
Up three steps to the helmdeck, with single Pompanette pedestal helmseat (2014), wheel, recent custom display for electronics, controls, and engine instrumentation to starboard. Opposite, to port, is the teak chart locker, storage below, comfortable L-shaped settee (new cushions Spring, 2016) with abundant storage underneath and a varnished teak grate table alongside. The helmdeck sole is laid teak decking.
OTTER's current owner commissioned the well-known Cumberland Ironworks, Pownal, ME, to design and custom fabricate OTTER's hardtop.The entire hardtop was subsequently completed and installed by a craftsman at Cove Landing Marine, Lyme, CT. There are (6) dimmer controlled interior down-lights, and aft, are (6) dimmer controlled wash lights for the cockpit. The full enclosure allows exceptional visibility, light and extra headroom. It can be either opened for ventilation, or closed, when helmsman and guests need protection from the elements.
The exterior teak cockpit allows room for guest seating on the aft-facing seat, on deck chairs or on the coaming. There is a cockpit shower and a transom door leading to the teak swim platform with swim ladder. St. Croix removable dinghy davits were professionally installed and reinforced for use when a dinghy is aboard.
Steps lead up to the wide side and foredecks with stainless steel safety rails and grab rails.
The U-Shaped Galley is Equipped as Follows:
The Galley is U-Shaped , with sink in forward facing area, Refrigerator under the counter facing aft. The Microwave is above the counter. There is generous storage under and above counters, in drawers and in lockers.
EXCLUSIONS: Shall be personal items, also any items not specifically mentioned in the above inventory.
Brewer Dauntless Shipyard
37 Pratt St
Essex, CT 06426