1984 Herreshoff Nereia

EUR  107,121
Gananoque, ON
  • Photo
  • Vidéo
Ce bateau vous intéresse ? Appel gratuit: 888-293-6544
Téléphone: 905-891-6764
  • Description
  • Voir toutes les caractéristiques

Price just reduced

Type de moteur/essence:
Monomoteur / diesel
Situé en:
Gananoque, ON
Matériau de la coque:
Prix actuel:
US$ 119,900 (EUR  107,121) 

One of a Kind Herreshoff Aluminium Nereia Ketch 1984 Commissioned 1999

ALL TALK was commissioned from one of the World's foremost aluminium boat builders for nearshore and offshore shorthanded cruising in remote areas by an experienced couple. The original Herreshoff rig was modified by US yacht designer Chuck Paine to take into account the greater ballast ratio (11,000 lbs embedded lead) allowed by aluminium hull construction. As a result, All Talk is a stiff, fast, weatherly vessel capable of carrying full sail in most conditions while demonstrating an easy motion and good speed under various reefing combinations. The long keel, transom-hung rudder, tiller steering, dependable four-cylinder Yanmar diesel and offset shaft with a 16x11 Hawboldt three bladed propeller allow for comfortable fuel-efficient (2/lh @ 2,000 rpm) motor sailing and superior control in reverse. This is an exceptionally easy vessel to singlehand.

Construction - The builder's mandate was to remain true to US yacht designer L. Francis Herreshoff's 1947 design while incorporating the best practices of French  aluminium boat building with regards to the alloys and welding schedules used in All Talk's construction. The hull, deck and house are a monocoque structure with ribs (every 24") and stringers (every 18") cut from 5 and 6 series alloys (5086, 6061T6) offering excellent saltwater corrosion resistance. Stanchions, pulpit and pushpit are solid 6061T alloy bar, socketed and bolted into bases enabling them to be removed for inspection and re-coating. All chainplates and bollards at bow, midships and stern are structural. The result is a tremendously strong, stiff hull and deck which allows the rig to be set up taut and remain so.

Deck and Rig - The forepeak and cockpit locker access hatches are lockable gasketed welded aluminium with screw-down dogs to seal them in extreme conditions. The four Lewmar Ocean hatches were installed in 2014. The portlights (four per side and two at the fore end of the house) consist of inner and outer 6 mm Lexan lenses through-bolted with SS bolts and lock nuts every three inches, sandwiching a butyl rubber seal.

The EB Spars rig was engineered by professional rigger Evert Bastet to be owner-serviced anywhere in the world. Both masts are keel-stepped with Spartite cast-resin partners. Sta-Lock and Acmo swageless terminals allow non-destructive inspection. All SS standing rigging is oversized and has never seen salt water. The 50' tapered mainmast and boom are from Charleston Spars; the 40' tapered mizzen is a custom French extrusion. The working sails - 100% jib, double reefing mainsail and single deep-reefing mizzen - are by Michele Stevens Sailloft (Lunenberg, NS, Canada). All are in good to very good condition.

Sailhandling gear is Harken, Berensen and Ronstan. Three sheet winches are Harken/Barbarossa #46 self-tailing, halyard winches are also Harken/Barbarossa. Main, genoa and staysail travellers are Harken, as is the jib furler. During construction, provision was made for hoisting and sheeting a light-air genoa and mizzen staysail. Lazyjacks on both main and mizzen ease the task of lowering and furling sails.

Mechanical - All mechanical and electrical systems were engineered to be owner-serviced with ease of access via a removable engine box and bulkhead access. This includes the Yanmar 4JHE and stuffing box, Isotemp six-gallon hot-water heater, Webasto Airtop 3500 central forced air heating system, batteries and fuel tank. Fuel capacity is 100 US gallons; water, holding are each 250 litres in flexible Vetus bladders with space in bilge compartments to double that capacity. Three bilge pumps include two Whale 1100 automatics and a Plastimo double-action diaphragm pump.

Layout - Forepeak accessed by a separate deck hatch provides ample room to store fenders, lines, boathooks, spare anchor, jerrycans, spares and access to the GDI 1500-watt vertical windlass and chain locker below. (All Talk currently carries 60' of chain and 200' 3/4" nylon rode with a single 45-lbs CQR). Provision was made for dual rollers on the laminated Douglas fir bowsprit and all-chain rode.

The forepeak is separated from the living space by a 5 cm (2") insulated watertight bulkhead to ensure the crew's survival in the event of a collision. Aft of that is the private forward cabin, with eight-foot double bunk to port, hanging locker and six-foot single bunk to starboard.

Aft of that is the head to port, with a heated hanging locker for foul weather gear, shower sump, toilet and SS sink inset in a Corian countertop. Wye valve allows wastewater to be pumped overboard or into the holding tank; the handle of the Forespar Marelon through-hull is removable to comply with Great Lakes discharge regulations. All five through-hulls and four of the five seacocks are Marelon; the engine's cooling water intake is controlled by a SS ball valve. All are easily accessible and cycled regularly to ensure dependable operation.

To starboard of the head is the linear galley. The Plastimo Azores three-burner gimballed stove top and oven is directly beneath an overhead hatch and fed by a 20-lbs aluminium tank in a sealed propane locker drained overboard with a Xintex Fireboy remote shutoff in the galley. Beside the stove is a Seaswing gimballed alcohol stove for when conditions are too rough to use the main stove. The deep 24" round sink drains well on both tacks. Galley and head sinks are supplied with hot and cold pressurized water. Foot pumps on both sinks can be connected to seawater or tanks.The top-loading refrigerator is equipped with an energy-efficient Waeco/Danfoss chiller unit and is insulated with a minimium of 10 cm (4") of closed-cell polyurethane foam and a double-sealed hatch/cutting board. The galley countertop is Corian.

To port is an elevated sitting and dining area which converts into a double seaberth. A square pedestal  table folds out to create a dining area for four people. At the aft end is a six-foot quarter berth and access hatch to the machinery spaces. To starboard, aft of the galley is bench seating beneath the companionway with insulated bins below and a large pantry and storage lockers outboard.

Electrical - Twin master switches, one dedicated to the 1000 MCA cranking battery, the other for the three AGM 88AH Group 24 house batteries. Banks can only be linked by turning both switches to BOTH. All are fused close to the batteries; starter and windlass circuits are also protected with 300-amp breakers. All circuits are equipped with breakers on two 12 VDC panels.

The 120V AC panel includes breakers for the hot water heater and 15-amp Professional Mariner Flyback charger. AC outlet is breaker and GFI protected. A cathodic protection system, galvanic isolator and reverse-polarity indicator provide protection from, and warning of, possible stray current corrosion.

Battery charging is achieved mainly with two Hitachi 85-watt solar panels atop of the dodger. Average bright-cloudy output is more than ample to cover refrigeration, navigation and electronics needs. A 30-amp solar output controller and battery readout next to the companionway allows easy monitoring of the state of charge.

VDO instrumentation includes voltmeter, ammeter, knot meter and log, trim indicator, depth sounder and anchor alert. Yanmar instrumentation includes tachometer, engine hour meter, oil pressure and water temp analog pressure gauges as well as visual and audio warnings for oil pressure and water temperature. A Plastimo Olympic compass is mounted on a binnacle on the aft side of the mizzen immediately above the instrument pod at the front of the cockpit.

Paint and Coatings - Although aluminium boats do not require painting above the waterline, All Talk's owners/builders opted for a classic colour scheme that would be easy to maintain. All Talk's deck and house were prepped with International Primewash and finished with two-part International linear polyurethane (Hatteras Off-White). The anti-skid is Durabak, a hard-wearing commercial marine product consisting of rubber granules in one-part linear polyurethane (Bristol Beige). The hull above the waterline was treated with Primewash, followed by two coats of high-build epoxy primer and four coats of International Brightsides (Endeavour Blue). The trim and waterline have Brightsides (Bristol Beige), the under water surfaces have been coated with zinc chromate, vinylester, International Tri-Lux II (Black). The bowsprit is treated with Sikkens Part 1 original, the tiller and companionway drop boards are finished bright, the only two exterior varnished surfaces on the vessel. All inside aluminium components, including ribs, stringers, plating, floors, mast partners, engine beds and bulkheads were prepped with sprayed on coal tar epoxy. The bulkheads are of 5/8" exterior fir plywood, epoxy saturated and faired with epoxy. All other structural wooden components have been epoxy saturated.

Safety and Cruising Equipment - All Talk carries a full complement of safety equipment, including double lifelines, jack lines, safety harnesses, life jackets and life buoys, flares, fire extinguishers, horn, search lights and sealed-beam units on the mizzen spreaders and mid mainmast to light up the deck. Hard-wired VHF is located next to the companionway. Swim and emergency ladders are easily accessible and deployable. Fenders, lines, spares, and the usual cruising paraphernalia find plenty of space in the forepeak and cockpit lockers. The machinery space is equipped with a smoke alarm. A CO detector is located in the forward cabin and covers the living quarters.

A full enclosure, folding seats and cockpit cushions provide an additional measure of comfort for crew and passengers. As Herreshoff explains in the chapter on the Nereia in his Sensible Cruising Designs, the well deck is the perfect lounging area while the crew works the boat from the cockpit. All Talk's owners can vouch for that, they have taken as many as a dozen people day sailing in comfort, safety and security.

In All Talk's most recent survey (November 2012), Michel Hebert wrote: "All Talk was built by Chaudronnerie Navale Guiberteau, a well-known manufacturer of welded aluminium boats. This is a fine example of a very well built boat. It is sturdy, a solid vessel ready for blue water navigation. The interior is well designed and the woodwork is exemplary and was very well taken care of. Most systems (engine, water, head, electrical) are over sized, confirming its purpose for extended cruises"

A custom built steel winter storage cradle is included.

New parts added Spring 2017: PYI dripless shaft seal; 25-Amp Cristec smart charger, Thordon shaft bearing and all new premium hose and ducting.

This is a must see for any mariner who demands quality, strength, stability, efficiency and performance in a vessel. This is a custom one-off, there is only one of these on the seas.

For more information about this one of a kind, amazing sailing vessel, or to set a viewing date please contact Barry Weaymouth, at barry@northsouthyachtsales.com, or call 613-213-2753. *

*Please Note: If you have had recent contact with a NSNG Broker, please contact that Broker for information on all NSNG listings.

Please contact Barry Weaymouth at 613-213-2753

Ce bateau vous intéresse ? Appel gratuit: 888-293-6544
Téléphone: 905-891-6764
Visiter le site web
Envoyez nous SVP un e-mail
Merci de saisir un nom
Merci de corriger l'adresse email
RE: Herreshoff Nereia, Gananoque, ON
Message est un champs requis qui ne peut pas être vide
Envoi en cours

Appel gratuit: 888-293-6544
Téléphone: 905-891-6764
North South Nautical Group

1 Port Street East
Port Credit, ON L5G 4N1

North South Nautical Group
Merci de saisir un nom
Merci de corriger l'adresse email
Message est un champs requis qui ne peut pas être vide
Envoi en cours
Ce bateau vous intéresse ? Appel gratuit: 888-293-6544
Téléphone: 905-891-6764